Motor-Motor mount finished3086 viewsPainted all prettyFeb 13, 2009
|
|
Motor-Motor mount drilled2373 viewsMounting holes drilled and primer applied.Feb 13, 2009
|
|
Bigger holes in the Impulse 92146 viewsWe decided that the rather small bolt holes in the end bells of the Impulse 9" motors were just too small.
So we drilled and tapped all of them out to a 7/16" bolt thread.Feb 13, 2009
|
|
Motor-Motor mount test fit2576 viewsHow it fits on one of the motors.Feb 13, 2009
|
|
Motor-Motor mount welded2216 viewsHere is the mostly finished mount all welded together.Feb 13, 2009
|
|
Motor-Motor mount access holes2441 viewsIt was interesting putting the access holes in the mount.Feb 13, 2009
|
|
Motor-Motor mount rough2451 viewsHere is the mount after some work in the lathe on both the raw pieces.Feb 13, 2009
|
|
Motor-Motor mount body2324 viewsAnd a piece of old iron pipe from the same place.Feb 13, 2009
|
|
Motor-Motor mount ends3193 viewsWe started with some scrap plate steel from the local recycle place.Feb 13, 2009
|
|
|
|
|
|
|
