CasaDelGato - Images from the House of the Cat

Home > Electric Vehicle > Ford F250 EV Conversion > Assemble Motors 1

2008-04-18_15-28-44.JPG
Pulling the engine11416 viewsRemoving the 460cui gas engine. (Having a forklift really made this easier.)
All 762 pounds of it!
2009-01-25_13-25-56.JPG
Setting up to couple the motors4350 viewsThis is how we setup to couple the motors. Since both ends of the coupler are heated press-fit, once it's on. It's on. Forever.
2009-01-25_13-34-56.JPG
Putting coupler on 1st motor2683 viewsWe heated the coupler with a torch until it was VERY hot. Then we stil had to pound it down on the shaft.
Not a good sign.
2009-01-25_13-35-56.JPG
2nd motor 2376 viewsThen we quickly lowered the 2nd motor down into the coupler, and once again had to do some pounding.
Another bad sign.
2009-01-25_13-39-56.JPG
Cooling it all off3009 viewsCooling the coupler down to keep the bearings from getting cooked.
2009-01-25_13-49-26.JPG
Examining the result2257 viewsHere we are looking at the result, and finding that the motors had NOT pressed far enough into the coupler.
We had a 1/2" of extra space to deal with.
We were going to just add a 1/2" spacer, until we did some measuring, and found that the motors were NOT coupled straight. There was a definite wobble.
2009-01-25_20-34-32.JPG
Uncoupling the motors2483 viewsSo, we tried heating and prying to get the motors apart.
Nope, isn't going to work.
2009-01-29_11-40-06.JPG
Cut-em apart2402 viewsWe ended up cutting our pretty, brand-new home made with great effort, coupler apart with the cutting torch.
2009-01-29_14-18-12.JPG
Getting the coupler parts off2782 viewsThen we had to mount each of the motors in the lathe and cut the remaining parts of the coupler off the motor shafts. Being VERY careful to not nick or damage the motor shafts.
2009-01-29_15-37-46.JPG
Coupler almost off3326 viewsThis is the coupler when it's just about cut off.
We would cut down to the keyway in the coupler, then we could pry it open just enough to tap it off the shaft.
2009-02-14_12-53-28.JPG
Position motors10533 viewsMotors were mounted to the transmission, then lifted in from below.
Transmission was then bolted to it's mounts, and the motors placed on blocks to keep everything in position
2009-02-15_17-09-34.JPG
Building Motor Mounting Framework9577 viewsWe decided it was easiest to juts build the motor mounting framework in place. Carefully cut pieces and clamp them in place, then tack weld it all together.
17 files on 2 page(s) 1