CasaDelGato - Images from the House of the Cat

Home > Electric Vehicle > Ford F250 EV Conversion

Most viewed - Ford F250 EV Conversion
2008-04-12_11-18-42.jpg
Front Gas Tank3420 views
2009-04-05_13-33-00.JPG
Zilla Coolant Pump3365 viewsI bought a submersible pump for the Z2K cooling. I'm going to use the existing coolant reservoir from the truck as the tank.
I had to cut a hole in the top so I could insert the pump.
2009-05-10_15-34-56.JPG
Battery Box Mount3360 viewsThere are 2 5/8" bolts at the back of the box to hold the box down to the bed. To keep these from pulling through the wood/fiberglass box, I put a long 1/4" thick steel plate behind each bolt.
2009-05-10_15-35-08.JPG
Battery Box Mount 3319 viewsThere are 2 more 5/8" bolts at the front of the box, with another steel plate for them.
2009-04-29_16-09-38.JPG
Motor wiring, parallel3311 viewsThis shows how I originally wired the 2 motors in parallel to the Z2K controller.
2009-01-29_15-37-46.JPG
Coupler almost off3310 viewsThis is the coupler when it's just about cut off.
We would cut down to the keyway in the coupler, then we could pry it open just enough to tap it off the shaft.
2009-01-07_11-11-18.JPG
Starting the Flywheel adapter3306 viewsThe flywheel adapter started as a big chunk of steel.
2009-04-13_15-18-46.JPG
Breaker Box (again)3244 views
2009-02-21_10-56-04.JPG
3194 views
2008-12-27_11-47-24.JPG
Motor-Motor mount ends3191 viewsWe started with some scrap plate steel from the local recycle place.
2009-05-15_14-38-20.JPG
240v charge port3132 views
2009-05-15_14-38-28.JPG
240v charge port3116 views
118 files on 10 page(s) 6