Motor-Motor mount ends3194 viewsWe started with some scrap plate steel from the local recycle place.
|
|
Motor-Motor mount finished3087 viewsPainted all pretty
|
|
Motor-Motor mount test fit2578 viewsHow it fits on one of the motors.
|
|
Motor-Motor mount rough2452 viewsHere is the mount after some work in the lathe on both the raw pieces.
|
|
Motor-Motor mount access holes2442 viewsIt was interesting putting the access holes in the mount.
|
|
Motor-Motor mount drilled2374 viewsMounting holes drilled and primer applied.
|
|
Motor-Motor mount body2325 viewsAnd a piece of old iron pipe from the same place.
|
|
Motor-Motor mount welded2217 viewsHere is the mostly finished mount all welded together.
|
|
Bigger holes in the Impulse 92147 viewsWe decided that the rather small bolt holes in the end bells of the Impulse 9" motors were just too small.
So we drilled and tapped all of them out to a 7/16" bolt thread.
|
|
|
|
|
|