Motors Wired4247 viewsI wired the motors to the Z2K using 4/0 cable.
Notice that I don't like exposed High Voltage connections. Couldn't do much about the 1000A shunt though.
(1 votes)
|
|
Motors Installed8870 viewsEverything is in and bolted down. The framework is mounted to the original rubber engine mounts that used to support the 460cui Gas Engine.
(1 votes)
|
|
Position motors10475 viewsMotors were mounted to the transmission, then lifted in from below.
Transmission was then bolted to it's mounts, and the motors placed on blocks to keep everything in position
(1 votes)
|
|
Building Motor Mounting Framework9520 viewsWe decided it was easiest to juts build the motor mounting framework in place. Carefully cut pieces and clamp them in place, then tack weld it all together.
(1 votes)
|
|
|
|
