CasaDelGato - Images from the House of the Cat

Home > Electric Vehicle > Ford F250 EV Conversion > Misc Items

2009-03-19_13-31-44.JPG
Motor Shroud for Blower5337 viewsThis is the shroud I wrap around each motor (Brush end) to connect the ductwork from the blower.
It's made out of 4" wide aluminum flashing. Just cut with a carpet knife, and flex the cuts apart.
2009-03-19_13-51-14.JPG
Blower to cool the motors4691 viewsThis is a 3 speed 12V blower I got from Surplus center.
I plan on having it come on in low speed whenever I turn the truck on, and it will switch to hi-speed if any of the motor thermostats trigger.
2009-03-20_13-09-58.JPG
Zilla Mounted4249 viewsThis shows where the Z2K Controller is mounted.
2009-03-20_13-10-06.JPG
Zilla Mounted2753 viewsA closer view of the Z2K mount
2009-04-05_13-33-00.JPG
Zilla Coolant Pump3369 viewsI bought a submersible pump for the Z2K cooling. I'm going to use the existing coolant reservoir from the truck as the tank.
I had to cut a hole in the top so I could insert the pump.
2009-04-08_09-30-14.JPG
Motor Cooling blower3096 viewsThis is the ductwork box I had to build so I can run a hose to each motor.
The box is built out of 3/16" ABS. The blue plate is a metal mounting plate so I can bolt the assembly to the frame.
2009-04-08_15-50-58.JPG
Blower Mounted2815 viewsAt the back left you can see where the Blower has been mounted. It blows down into the box I built, and there is a 3" flex tube running to the shroud on each motor.
2009-04-08_15-54-08.JPG
RPM sensor4671 viewsThis shows how I mounted the Z2K RPM sensor to the tailshaft of the motor.
2009-04-13_15-18-46.JPG
Mechanical link between Breakers3732 viewsThis shows how I made it so that only 1 of the 2 power inlet breakers can be ON at a time.
Both can be off, but only 1 can be ON.
2009-04-19_14-52-30.JPG
Central Wiring area4128 viewsThis is where most of the control wiring will be.
It's not done yet in this photo.
The meters are the AC Amps and Volts for the PFV-50 input.
2009-04-29_16-09-38.JPG
Motor wiring, parallel3318 viewsThis shows how I originally wired the 2 motors in parallel to the Z2K controller.
2009-05-04_17-45-58.JPG
Control Wiring3695 viewsThis is the main control wiring for the EV conversion. It has the Z2K Hairball, and all the various relays, meters, fuses, etc..
The 2 meters are AC Amps and Volts for the PFC-50 charger.
18 files on 2 page(s) 1